Ramsey Electronics SG560 Guide de l'utilisateur télécharger pdf (Page 56)

TYPICAL TEST PROCEDURES

STEP-3 INSERTION LOSS FINAL TEST

1. Leave the RF OUT cable connected to the duplexer antenna port. You can final test the

duplexer to make sure that it is operating correctly by an insertion loss test.

2. While the RECEIVE IN is connected to the transmitter side of the duplexer, switch the

generator to the repeater transmit frequency. Make sure the 50 Ohm load is connected

to the repeater receiver port.

3. You can now determine the insertion loss in db by adding the generator dbm value to

the RSSI value. Example Generator – 90 dbm and Receiver RSSI – 91.5 dbm = 1.5 db

insertion loss. It should be close to the manufacturer’s specifications.

4. Likewise move the cable from the RECEIVE IN to the receiver side of the duplexer.

Switch the generator to the repeater receiver frequency. Make sure the 50 Ohm load is

connected to the repeater transmitter port.

5. You can now determine the receiver insertion loss in db by adding the generator dbm

value to the RSSI value. Example Generator – 90 dbm and Receiver RSSI – 91.5 dbm =

1.5 db insertion loss. It should also be close to the manufacturer’s specifications.

Your Notes:

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 103 104

Pas de commentaire

Ramsey Electronics SG560 Guide de l'utilisateur Page 56