Ramsey Electronics SG560 Guide de l'utilisateur télécharger pdf (Page 38)

TYPICAL TEST PROCEDURES

Your Notes:

3.10.02 Power Measurements (Continued)

6. Key the radio into the COM3010; the frequency counter will begin to count the RF

signal. The text to the right of the power meter will show “POWER GOOD” to indicate

that the count value and calibration are correct.

7. If the counter is not registering you will see “POWER UNCAL”. To remedy this, either use

the COUNT IF method or make sure the radio is keyed long enough for the frequency

counter to register a valid count.

8. The reading can be toggled between dBm (helps with loss calculations), and watts by

pressing LEVEL.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 103 104

Pas de commentaire

Ramsey Electronics SG560 Guide de l'utilisateur Page 38