Ramsey Electronics SG560 Guide de l'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 104
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
11
INTRODUCTION
Allows unit to be placed upright and rest on the rear panel.
R. Battery Input Jacks
Receptacles for connecting battery packs. These can also be used to connect an external DC
supply. See the BATTERY INFORMATION section for more details.
S. Battery Pack Support Rails
T. High-power attenuator heat sink
The high-power attenuator is located on the back of this heat sink inside of the case. During
power meter testing, this will become quite warm. During use, allow for plenty of air
circulation around the heat sink to allow normal convection cooling to occur. If this gets too
hot, it may cause power supply of the COM3010 to shut down to protect the batteries from
overheating. If performing a lot of power testing, it wouldn’t hurt to direct air flow at the heat
sink to keep it cool, though under normal testing circumstances, this will never be a problem.
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 103 104

Commentaires sur ces manuels

Pas de commentaire