Ramsey Electronics AM25 Manuel d'instructions télécharger pdf (Page 10)

AR1 • 10

 1 9-volt battery snap connector

 1 9-volt battery hold-down clamp

 1 AR1 printed circuit board

In ALL PC board assembly steps, our wor

d "INSTALL" means to do this:

• Insert the part, oriented or "pointed" correctly, into its holes in the

PC board.

• If helpful, gently BEND the part's wire leads or tabs to hold it into

place, with the body of the part snugly against the top side

("component side") of the circuit board.

• Solder ALL wires or pins of the part.

• Trim or "nip" all excess wire lengths extending beyond each solder

connection, taking care that wire trimmings do not become lodged

in solder connections.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Ramsey Electronics AM25 Manuel d'instructions Page 10