Ramsey Electronics VHF Low Noise Preamp Kit PR100 Manuel d'instructions télécharger pdf (Page 12)

PR100 y 12

THE PR100

Hookup is simple if you are using coax cable such as RG-58 or better 50 ohm

cable. Just run a piece from the jack marked RCVR (J3) on the PR100 to

the .01µF capacitor just before the radio. Then a short piece is needed to go

from the capacitor to the radio. Finally, you need to connect the Preamp to the

antenna and you are ready for testing.

HOOKUP EXAMPLE

Turn on your receiver, you should be able to pick up a weak signal with little

difficulty. If you are not receiving anything yet, check your 12 volt DC supply. If

you are still having troubles, test for the twelve volts present on the preamp,

then check the orientation of the preamp. If both are correct, you may need to

check your preamp for proper assembly, or even possibly your cabling for

opens. Consult the assembly instructions for some help on these matters.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Ramsey Electronics VHF Low Noise Preamp Kit PR100 Manuel d'instructions Page 12